Hello Everyone
I built a Buildroot image for my STM32MP157C-DK2 and I would like to enable Wifi and Ethernet.
Are there some specific packages that I need to install before doing so ?
I found this article here but I it is specific for an STM32 device with OpenSTLinux so I don't know if it is also possible to apply this method.
I worked with embedded Linux before and I always had a direct connection to ethernet through SSH. in my case ifconfig does not output an IP-Adress for eth0.
Any suggestion on how I should proceed in order to have Ethernet and then Wifi operating on my device?
Thank you.
p.s I am using a remote controle software: MobaXterm for SSH access
I built a Buildroot image for my STM32MP157C-DK2 and I would like to enable Wifi and Ethernet.
Are there some specific packages that I need to install before doing so ?
I found this article here but I it is specific for an STM32 device with OpenSTLinux so I don't know if it is also possible to apply this method.
I worked with embedded Linux before and I always had a direct connection to ethernet through SSH. in my case ifconfig does not output an IP-Adress for eth0.
Any suggestion on how I should proceed in order to have Ethernet and then Wifi operating on my device?
Thank you.
p.s I am using a remote controle software: MobaXterm for SSH access