Recent content by doac00

Thanks - but I don;t want to "mess" with any Netgear GUI here, don't want to try and write over anything at this moment in time - CLI into the unit I can see that it's LINUX based and Mdadm is used for the RAID assembly. I have allot of data on the device so clearly want to see if I can recover...

Folks New to forum so I apologize if this is the wrong section. I have a Netgear NAS that uses MDADM for it's software RAID. I have a RAID 6 setup and a failed disk which I duly replaced to only have the another disk fail while the new disk was syncing/striping etc... I'm not competent in...