I saw that there were two network cards but I thought it was because the laptop has a wired Ethernet port too.
I have no idea why there are two cards. my knowledge with linux is limited to that of an ordinary user. I just did the standard installation of Ubuntu.
I put my password and ran the command. The terminal was busy for a while and then this message returned:
$ nmcli radio wifi on
$ sudo nmcli dev wifi connect 'Bat Signal 2.4GHz' password 'my_pass'
[sudo] password for humberto:
Error: Connection activation failed: (7) Secrets were required, but...
I've been looking for "Intel Cannon Point-LP CNVi [Wireless-AC]" and found this drive on this site:
https://linux-hardware.org/index.php?id=pci:8086-9df0-8086-0034
I ended up hitting a page on github but I have no idea what to do with it...
That's the output when I run "systemctl status -l wpa_supplicant". Thanks
$ systemctl status -l wpa_supplicant
● wpa_supplicant.service - WPA supplicant
Loaded: loaded (/lib/systemd/system/wpa_supplicant.service; enabled; vendor preset: enabled)
Active: active (running) since Thu...
I am a recent Linux user, I've basic notions with the terminal. I've been researching what you said and I'll try to find more about drivers on the internet, thanks.
output from iw list:
$ iw list
Wiphy phy0
wiphy index: 0
max # scan SSIDs: 20
max scan IEs length: 422 bytes
max # sched scan SSIDs: 20
max # match sets: 11
max # scan plans: 2
max scan plan interval: 65535
max scan plan iterations: 254
Retry short limit: 7...
This week I acquired a TP-Link Dual Band AC 1350 Archer C60 Wireless Router, configured the two networks (2.4GHz and 5GHz) and it's working correctly (in parts).
On my cell phone and all other cell phones here at home, both 2.4 and 5GHz networks normally work. I also connected my Echo Dot that...