I run adv tomato on an Asus router at home, I setup a guest wifi without issues, my network at home is a simple setup, Modem in bridge mode going into Asus Router wan port.
At my office I have the same Asus router, I tried to setup the guest wifi option but I am unable to do so my setup at the office is slightly more complex. Modem in bridge mode into a pfsense FW / Router into a switch (no vlans) into a LAN port of my Asus Tomato router.
When I replicate my setup at home for my guest wifi I have no internet access on my guest wifi at my office, I have copied everything exactly the same as outlined here. https://learntomato.flashrouters.com/setup-guest-network-guest-wifi-tomato-vlan/
But I think because switch is being uplinked through the lan port I am unable to create the guest wifi. If I create a wifi on the Asus router I have it works fine, but this will not work for the guest wifi.
In Advanced Settings under Vlan / Wireless I have
Bridge (Eth1 to Lan Br0) main Wifi (non guest) working
My Vlan (guest wifi)
Bridge (wl0.1 to Br1) no wifi if I bridge (wl0.1 to Br0) it works, but I’m on the wrong ip range (my internal lan)
Any Advice would be appreciated.
At my office I have the same Asus router, I tried to setup the guest wifi option but I am unable to do so my setup at the office is slightly more complex. Modem in bridge mode into a pfsense FW / Router into a switch (no vlans) into a LAN port of my Asus Tomato router.
When I replicate my setup at home for my guest wifi I have no internet access on my guest wifi at my office, I have copied everything exactly the same as outlined here. https://learntomato.flashrouters.com/setup-guest-network-guest-wifi-tomato-vlan/
But I think because switch is being uplinked through the lan port I am unable to create the guest wifi. If I create a wifi on the Asus router I have it works fine, but this will not work for the guest wifi.
In Advanced Settings under Vlan / Wireless I have
Bridge (Eth1 to Lan Br0) main Wifi (non guest) working
My Vlan (guest wifi)
Bridge (wl0.1 to Br1) no wifi if I bridge (wl0.1 to Br0) it works, but I’m on the wrong ip range (my internal lan)
Any Advice would be appreciated.