Kali Linux - Black Screen after boot on Hardware ! HELP PLEASE !

[romangaitur2024]

good evening. please tell me what to do ? after installing Kali, namely at startup, there is a dash in the upper left corner - after which a black screen. I waited a very long time for the launch, but it didn't help. maybe something needs to be fixed in the bios ? in the bios, the secure boot is not activated. fast loading is activated - tried and disable. I'm talking about installing not on a virtual machine but on hardware. I apologize in advance for my English and if you have any questions, ask - because the problem needs to be solved.

 

[osprey]

You could try to boot up with the kernel parameter: nomodeset, and see if that gets you a graphics display. It often works, but is a stop gap measure until you sort out the graphics driver issues, which are possible causes of this problem. It's likely best to turn off "fast booting" too.

 

[Brickwizard]

Why Linux fails to load/install direct to HDD, common reasons
1] Corrupt download [check SHA sum]
2] bad burn to installation medium [try again] [if you used Rufus then try Balina-etcher]
3] Wind 8.2 and higher quick start/fast boot or secure boot not disabled [doesn't normally apply to older versions]
4] defective pen-drive/dvd
5] hardware fault,
5A] If old style HDD run integrity check
5B]if SATA SSD check for hidden partition at the beginning of drive [this will stop Grub from loading] and delete it before re-installing Linux
If M2.NVMe check, your system is NVMe compatible [not all older kit is]